Engineers Able To Come To Client Factory For Machine Installation And Commissioning
filling line machine
filling and capping machine
PREFORM WATER JUICE SOFT BLOWING-FILLING-CAPPING MACHINE FOR PET BOTTLES
Blowing-Filling-Capping Combi-block,one equipment can complete all processes including bottle blowing, filling and capping, an innovative packing technology that can complete the whole process from preform to bottled liquid products.
Sunswell is one of the few suppliers who masters both “PET blowing molding” and “filling” technologies. Based on experience on complete line management, combining “PET blowing molding” technology and “filling” technology, with innovation at on-line forming technology, blowing ,filling process and filling device, the BFC decrease energy by 25%, which fill domestic blank and reach international level.
By eliminating conveying, empty-bottle handling, accumulation and storage, Combis optimise line layout with a smaller footprint, improving production hygiene and efficiency while lowering operating costs.
It is applied to PET bottled pure water, carbonated soft drink, juice, liquid dairy, liquid condiment and household & personal care products, etc.
1. Pre-form inlet controlling
2. Put pre-forms into hopper of auto sending device, send to heating stove through belt and drum unit.
3. Bottle pre-form heating controlling The heating stove has 8-floors infrared lamp to heat pre-forms, the pre-forms run itself and also the infrared lamp can be adjusted temperature independently.
4. Heating stove has pre-form screw head cooling way and stove ventilation and cool air duct, it ensures that pre-forms will not be hard warmed.
5. Bottle pre-forms are sent to pre-form base by guide turn table, the bases get pre-forms and then send to stove for heating one by one.
6. Blowing technology controlling
7. Discharge warmed pre-forms to outlet guide by discharge pre-form cover, put pre-forms into blowing moulds by manipulator, seal the bottle mouth and extrude the body, also inlet two grade air pressure(pre-blowing pressure and high pressure air) and make pre-form to be bottles. According to the requirement of art, there will inlet cooling water for moulds, all above processes are controlled by main machine computer.
8. Bottle check and outlet
9. After blowing, the manipulator get bottles out of mould and the qualified bottle will be send to guide, this guide can be connected directly to filling line and also can connect to conveying chain, send to bottle warehouse.